Full system diagnostic
We test the thermostat, control board, capacitors, contactors, blower motor, and refrigerant charge. Diagnosis takes 20 to 40 minutes and covers both the heating and cooling sides of the system.
24/7 HVAC repair in Milwaukie, Oregon for no-heat and no-cool calls
Emergency HVAC repair Milwaukie OR that gets your heat back tonight
When your furnace dies at 2 a.m. or your AC quits during a Milwaukie heat wave, emergency HVAC repair Milwaukie OR gets a licensed tech to your door fast. We run 24/7 HVAC repair Milwaukie Oregon calls across Clackamas County, diagnose the fault, and fix it on the first visit whenever the part is on the truck. No heat, no cooling, no waiting until Monday.
Careful work. Honest options.
About this service
emergency HVAC repair Milwaukie OR: what actually happens
Emergency HVAC repair Milwaukie OR is the after-hours service call that restores heating or cooling when your system stops working and you cannot wait for a weekday appointment. A tech arrives with manifold gauges, a multimeter, and a leak detector, then works through the likely failures in order: thermostat malfunction, tripped breaker, failed capacitor or contactor, dirty air filter, blower motor failure, refrigerant leak, or a clogged condensate drain. Most no-heat and no-cool calls trace back to one of those eight faults.
Milwaukie homes sit in a wet, mild-winter climate that hides problems until they bite. Furnaces short-cycle through damp January nights, heat pumps ice over during a 38-degree cold snap, and older AC units in Ardenwald and Hector Campbell quit on the first 95-degree afternoon. If you are searching emergency HVAC near me Milwaukie at midnight, we answer the phone, quote a real range before we roll, and send a truck. That is the whole point of 24/7 HVAC repair Milwaukie Oregon.
- ✓ Same-day emergency dispatch
- ✓ Parts stocked on the truck
- ✓ Flat diagnosis, no surprise add-ons
- ✓ Licensed, bonded, code-correct
What's included
What our emergency HVAC repair includes
Every emergency HVAC repair Milwaukie OR call includes a full diagnostic, an upfront written price, the repair itself, and a system test before we leave. Parts and labor are warrantied. Here is what is covered on a standard emergency visit, and what we quote separately if your system needs it.
Upfront written pricing
You get parts and labor itemized before we start. No hourly guessing, no surprise add-ons. If the repair is not worth doing, we tell you and quote replacement instead.
On-truck part replacement
Capacitors, contactors, igniters, thermostats, blower motors, and R-410A refrigerant are stocked on the van. Roughly 8 in 10 emergency calls are fixed on the first visit.
Refrigerant leak repair and recharge
We locate leaks with an electronic leak detector, repair the line, evacuate with a vacuum pump, and recharge by weight with R-410A. EPA Section 608 handling rules apply on every job.
Condensate drain clearing
A clogged condensate line is one of the most common causes of AC shutdowns. We clear the PVC line, flush the trap, and check for proper slope so it does not back up again next season.
Full system test and walkthrough
We run a complete heating or cooling cycle, verify supply air temperature, and show you what failed and what we replaced. You leave with the invoice, parts warranty, and workmanship warranty in writing.
How it works
What to expect on an emergency call
You call (855) 947-9500 and talk to a real person, not a call center. We ask what the system is doing, how old it is, and whether you smell gas or see ice. That five-minute conversation tells us which parts to load and whether this is a safety call that needs a faster response.
A tech arrives in the window we quoted, usually 60 to 120 minutes for standard calls. They test the thermostat, check voltage at the contactor, read pressures with manifold gauges, and inspect the air filter and condensate line. Diagnosis takes 20 to 40 minutes and you get a plain-English explanation of the fault.
Before any repair starts, you get a written price: parts, labor, and any code-required items. No hourly guessing. If the fix is not worth doing on a 20-year-old unit, we tell you that too and quote replacement instead of charging you for a patch.
Most repairs take one to three hours. We replace the failed component, recharge refrigerant if there is a leak, clear the condensate drain, and then run the system through a full heating or cooling cycle. We do not pack up until the supply air is at the right temperature.
We show you what failed, what we replaced, and what to watch for. You get the invoice, the parts warranty, and our workmanship warranty in writing. If the same fault returns inside the warranty window, the return visit is on us.
STEP 01Phone triage
You call (855) 947-9500 and talk to a real person, not a call center. We ask what the system is doing, how old it is, and whether you smell gas or see ice. That five-minute conversation tells us which parts to load and whether this is a safety call that needs a faster response.
Tools & methods
Tools and methods we use
Manifold gauges
Used to read high-side and low-side refrigerant pressures and diagnose charge problems on AC and heat pump calls.
Vacuum pump and recovery machine
We pull a deep vacuum before recharging and recover refrigerant per EPA Section 608 rules. No venting, no shortcuts.
Multimeter and clamp meter
Used to test voltage, capacitance, and amp draw on capacitors, contactors, blower motors, and compressors.
Electronic leak detector
Finds refrigerant leaks in copper tubing and coils that a visual inspection would miss, so we repair the leak instead of just recharging.
Fin comb and coil cleaning tools
Straighten bent condenser fins and clean coils to restore airflow and efficiency after a repair.
Duct cleaning vacuum
Removes debris and dust from ductwork after a blower motor failure or during a related air duct cleaning visit.
Real results
Before and after.
emergency HVAC repair
No heat at 2 a.m. in Ardenwald
A 2004 Carrier furnace quit on a 26-degree January night. Indoor temp dropped to 57 degrees by 3 a.m. The homeowner had already reset the breaker twice with no luck.
After: We replaced a failed hot surface igniter and a weak flame sensor, then verified a 45-degree temperature rise. Heat was back on by 4:15 a.m. Total cost: $340, exactly as quoted.
Book this service →
emergency HVAC repair
AC down during an August heat wave
A 2012 Trane AC stopped cooling on a 97-degree Saturday in Oak Grove. Indoor temp hit 86 degrees by mid-afternoon. The condenser fan was running but the compressor was not.
After: We found a bulged run capacitor and a clogged condensate drain. Replaced the capacitor, cleared the drain, and recharged 8 ounces of R-410A after locating a small Schrader valve leak. Cold air restored in under three hours.
Book this service →
emergency HVAC repair
Heat pump icing over in December
A 2019 Mitsubishi Electric heat pump in Lake Road was icing over every few hours and blowing cold air. The homeowner was running emergency heat and watching the meter spin.
After: We diagnosed a failed defrost control board, replaced it with an on-truck part, and tested the defrost cycle twice. The system returned to normal operation with warm supply air and a lower electric draw.
Book this service → Problems we solve
Problems we solve on emergency HVAC calls
Most emergency HVAC repair near me Milwaukie OR calls come down to a handful of failures. Here are the ones we see most, what happens if you ignore them, and how we fix them.
Ask a pro →Furnace blowing cold air in January
We test the igniter, flame sensor, gas valve, and draft inducer. Most no-heat calls are a failed igniter or flame sensor, both of which we stock. Repair takes one to two hours and we verify the heat rise before we leave.
AC not cooling during a heat wave
We check the capacitor, contactor, condenser fan, and refrigerant charge. A weak capacitor is the most common cause and takes under an hour to replace. If the system is low on R-410A, we find and repair the leak first.
Heat pump frozen over in winter
We diagnose the defrost board, reversing valve, and outdoor sensor. A failed defrost board is a common fault and we carry replacements for Mitsubishi Electric and Daikin units. We also show you how to run emergency heat while it thaws.
Clogged condensate drain shutting down AC
We clear the PVC condensate line, flush the trap, and check the slope. If the line is undersized or poorly routed, we re-pipe it. This is a fast, inexpensive fix that prevents water damage.
Proof you can check
Licensed, certified, and reviewed
- NATE Certification · North American Technician Excellence
- EPA Section 608 · U.S. Environmental Protection Agency
- Oregon CCB License · Oregon Construction Contractors Board
- OSHA Safety Compliance · Occupational Safety and Health Administration
Most emergency HVAC repair Milwaukie OR calls run $180 to $650 in 2026, including the diagnostic fee and the repair. A capacitor or thermostat swap sits at the low end; a blower motor or refrigerant leak repair pushes toward the top. After-hours calls add a quoted overtime rate. You approve the price before we start, so the number does not move.
ThermexaPro answers 24/7 HVAC repair Milwaukie Oregon calls at (855) 947-9500, including nights, weekends, and holidays. A live dispatcher picks up, quotes an arrival window, and sends a licensed tech with parts on the van. We cover Milwaukie, Oak Grove, Gladstone, Oregon City, and the rest of Clackamas County.
Yes. Same-day emergency HVAC repair Milwaukie OR slots are available seven days a week for calls placed before 6 p.m. Overnight and holiday calls get a two-to-four-hour arrival window. If your furnace is out and the house is dropping below 60 degrees, tell the dispatcher and we move you up the queue.
First, check the thermostat batteries and the breaker, then check the air filter. If the system still will not run, call (855) 947-9500. If you smell gas, leave the house and call your gas utility first. For a frozen heat pump, switch to emergency heat and let it thaw while a tech is en route. Do not keep resetting a unit that trips the breaker.
Ready when you are
Need emergency HVAC repair Milwaukie OR right now?
Call (855) 947-9500 and a live dispatcher will quote an arrival window in under two minutes. Licensed, bonded, and stocked with the parts that fail most. We answer 24/7, including holidays, and we do not leave until your heat or cooling is back on.
Call Now (855) 947-9500 →
Request an appointment
Contact ThermexaPro in Milwaukie
Call (855) 947-9500 any time, day or night, and a live dispatcher will get a tech headed your way. Regular office hours run 8 a.m. to 6 p.m. Monday through Friday, with 24/7 emergency coverage for no-heat and no-cool calls. You can also email info@thermexapro.com and we will reply the same business day.
Call anytime(855) 947-9500Email the officeinfo@thermexapro.shop
Office hoursOpen 24 hours · 7 days a week